Tri Tool 212B Miter Mandrel User Manual
Page 10
10
TRI TOOL INC.
92-0449 : Orig. 930630
SETUP
The four (4) Jackscrews are removable.
They are made of heat-treated steel and have a slight spherical radius on the
surface that contacts the workpiece.
On most surfaces, this provides for excellent holding power with virtually no
marring of the workpiece.
Five (5) lengths of Jackscrews and two (2) lengths of Spacers are provided.
Refer to the ‘Jackscrew Assemblies and Spacers’ section.
Turn the Jackscrews to a diameter slightly smaller than of the ID of the workpiece.
Before the Miter Mandrel is mounted to the workpiece, the angular offset adjustment
should be approximately centered.
This will permit a maximum range of adjustment for final settings.
Check the gap between the Miter Mandrel Head and the Shaft Flange to see that it
is approximately even all the way around.
Checking the Miter Mandrel Gap
If it is not, loosen the Angular Offset Adjustment Screw(s) where the gap is
small and tighten the Angular Offset Adjustment Screw where the gap is
wide. Lightly tighten.
- 204B Cutting Head (9 pages)
- 204B Cutting Head (10 pages)
- 204B Cutting Head (9 pages)
- 212B Single Point Spring Hanger Assembly (8 pages)
- 204B Cutting Head (13 pages)
- 204B Cutting Head (36 pages)
- 204B Cutting Head (17 pages)
- 201BA Beveler (36 pages)
- 204B Elbow Mandrel (16 pages)
- 204B Beveler (45 pages)
- 204B Flange Facer (21 pages)
- 206B Elbow Mandrel (17 pages)
- 206B Flange Facer (22 pages)
- 206B Beveler (45 pages)
- 212B ID Tracking Module (17 pages)
- 206B Miter Mandrel (16 pages)
- 206B Sleeve Mandrel (13 pages)
- 208B Elbow Mandrel (20 pages)
- 208B ID Tracking Module (18 pages)
- 208B Miter Mandrel (20 pages)
- 208B Flange Facer (28 pages)
- 208B Sleeve Mandrel (15 pages)
- 212B Elbow Mandrel (16 pages)
- 214B Beveler Single Point Flange Facer (41 pages)
- 212B Flange Facer (22 pages)
- 212B Single Point Hydraulic Motor Assembly (9 pages)
- 212B Single Point Flange Facer Miter Mandrel (28 pages)
- 212B Sleeve Mandrel (12 pages)
- 214B Elbow Mandrel (20 pages)
- 214B Flange Facer (23 pages)
- 214B ID Track Module (19 pages)
- 214B Miter Mandrel Head Kit (22 pages)
- 214B Sleeve Mandrel (13 pages)
- 236B ID Tracking Module (23 pages)
- 224B Miter Mandrel (27 pages)
- 224B Single Point (30 pages)
- 230B Beveler Flange Facer (16 pages)
- 230B ID Tracking Module (15 pages)
- 230B Lifting Frame (19 pages)
- 236B Miter Mandrel (25 pages)
- 301SP Tube Squaring (35 pages)
- 236B Single Point (32 pages)
- 302 Tube Squaring Micro Feed Assembly (11 pages)
- 302 Tube Squaring (31 pages)