Desa (V)T32EN - Manual (Page 22)

www.desatech.com 108860-01D
FIREPLACE INSTALLATION
Continued
WALL SWItCH INStALLAtION
The installation of a wall switch allows you to activate the gas
control valve and turn the fireplace on and off. The wall switch is
to be connected to the incoming 120 volt regular household wir-
ing that supplies the electricity to the fireplace. Refer to wiring
diagram below.
OPtIONAL REMOtE CONtROL
INStALLAtION (MODEL WRC)
Note: If using optional wireless hand-held remote control, the wall
switch must be in the ON position to be operational. The remote
control then becomes the switching mechanism for fireplace op-
eration.
1. Open lower louver panel of firebox.
2. The WRC model receiver does not require a battery. The
receiver can be installed by first plugging the short extension
cord into the fireplace receptacle. Then plug the receiver unit
into the extension cord. Finally plug the ignition module plug
into the receiver unit (see Figure 46).
3. Activate the remote handset battery by removing the insulating
tab on the back of the handset (see Figure 47). The battery is
included pre-installed.
4. Once the battery is activated the unit is ready to use.
5. Close lower louver panel.
Figure 46 - Installing the WRC Remote Receiver
Fireplace
Receptacle
Remote Control
Receiver
Extension Cord
Ignition
Module Plug
Figure 47 - Installing Battery into Back of Handset
Pull to Remove
Insulation Tab
Battery Cover
1 Volt Battery
Back of
Handset
Robertshaw
MODEL
SP745 IGNITION CONTROL
STEP DOWN
TRANSFORMER
PV
GN
D
PV/MV
TR
MV
TH
IG
N
EV2
INCOMING MAIN
GAS SUPPLY
EV1
GAS LINE TO
BURNER
24V AC
120V AC
INCOMING
120V AC
(FUSE BOX
OR BREAKER)
OFF ON
(SUPPLIED)
WALL SWITCH
GREEN BLACK WHITE
120v, 60Hz, 0.7A
ELECTRICAL RATING:
BLACK
WHITE
GREEN
OPTIONAL
REMOTE
CONTROL
WIRING DIAGRAM
Pilot Burner
Pilot Gas
Line