Tiffen Lowel Scandles - Manual (Page 5)

Accessories
Collapsible Cone &
Front Diffuser
n The sections of the cone are
made of clear plastic and come with
installed reflective material, which
should be suitable for most lighting
purposes. Each section opens to allow
color gels, diffusion or other reflective
materials to be used for special pur-
pose lighting effects.
n Assemble the Collapsible Cone
by zipping the 3 sections together.
n Attach the narrow end
of the cone to the Mounting Ring by
lining up the 3 snaps.
n To attach the cone & ring
to the front of the rotating speed ring,
place the fixture with lamps & shield
installed on a table, facing up so that
it rests on its 4 rear panel support
feet, or securely on a stand, facing
straight up.
n Remove the 4 plastic retaining
nuts from the screw posts on the speed
ring and carefully place the cone over
the lamps so that its metal ring rests in
the recess of the ring. Replace the 4
plastic nuts and tighten securely.
If you want additional softness, attach
the front diffuser to the front of the
cone reflector by collapsing the cone
slightly to get the elastic of the diffuser
over it. Note: diffuser reduces output
by approximately 50%.
Hard Cone Reflector
n The Hard Cone Reflector
is designed for studio use. It is not
collapsible. Attach the Hard Cone
Reflector using the same procedure
as the Collapsible Cone.
n Place the fixture, with lamps
& shield installed, on a table facing
up so that it rests on its 4 rear panel
support feet.
n Remove the 4 plastic retaining
nuts from the screw posts on the speed
ring and carefully slide the reflector
over the lamps so that its metal ring
rests in the recess of the ring.
n Replace the 4 plastic nuts and
tighten securely. You can attach the
Lowel Fin-S clip adjustable barndoor
to the rim of the reflector for additional
light control.
Accessories
5