Lowel rifa ex retrofit instructions, Continued – Tiffen Lowel Rifa eX Retrofit User Manual

Page 2

Lowel Rifa eX Retrofit Instructions

continued

Step 3 - Installing the Lamphead

Step 4 - Wiring the IEC Connector

Reinstall the Plug Cover, and tighten IEC housing screw.

Lowel equipment and kits are sold through authorized Lowel Dealers and, in some countries, Authorized
Lowel Distributors. Repairs, problems, suggestions, and requests for brochures, instructions, parts lists
may be handled by your authorized Lowel Dealer (Distributor) or directly with Lowel. Electrical repairs
should be made only by Lowel or a qualified electrician. Rifa-lite

is a registered trademark of Lowel-

117

90 Oser Avenue, Hauppauge, N.Y. 11788
Call: 800 645-2522 or 631 273-2500

e-mail: [email protected]
www.lowel.com

Problems, info, repairs, etc.

Lowel-Light Manufacturing, Inc.

Disassemble the new IEC Connector completely by removing its
Cover, Plug Strain relief, & 2 screws holding the Strain Relief
Bar. Note that inside the IEC Connector, one screw is labeled N
and the other is labeled L. Center screw is Ground (see Detail).

Take the Power Cable of new core and feed it through the
Rubber IEC Strain Relief.

Place the conductors into terminal holes as shown, with White
wire to N, Black wire to L, and Green wire to Center. Install &
tighten the Green wire last. Tighten all firmly. After tightening,
position the Green wire so it clears center screw post.

Warning: Before closing IEC Connector, visually con-
firm that wires are connected to proper terminals.

White - N terminal
Black - L terminal
Green - Center terminal

Slide the IEC Strain Relief along the cable and return it to its
cutout channel in the IEC Connector. Replace the Strain Relief
bar and tighten firmly.

Tighten locking knob on rear of Rifa, and grasp rear stem firmly
as you install lamphead.

Attaching Warning Label

Untie the Rifa Carry Bag closure cord, and thread the Updated
Warnings label into it. Securely retie the knot.

Line up the J-hook cutouts on the side of the lamphead with the
side pins on the core. Note that 1 pin is larger than the other.
Push & twist to install the removable lamphead on the core.
When complete, remove Rifa from stand to wire the new IEC
connector.

Detail