Tiffen Lowel Rifa-lite - Manual (Page 4)

Rifa-lite ® Accessoriess
Replacement
Diffusers
Standard light diffuser replacements
for all 3 models of Rifa-lite.
Diffuser must always be used to pro-
tect against lamp explosion.
For LC-44
Code: LC-44D
Size: 16 x 16" (40 x 40 cm)
For LC-55
Code: LC-55D
Size: 21 x 21" (53.3 x 53.3 cm)
For LC-66
Code: LC-66D
Size: 25 x 25" (66 x 66 cm
For LC-88
Code: LC-88D
Size: 32 x 32" (81.3 x 81.3 cm)
Rifa Daylight Gel Sets
For correcting Rifas to mix with vary-
ing strengths of daylight, they attach
to Rifa’s velcro pockets with clothes-
pins.
Each set contains 3 sheets:
Day Blue; 1/2 Blue; & 1/4 Blue
(1 sheet each).
For LC-44
Code: LC-47
Size: 23 x 16" (58.4 x 40.6 cm)
For LC-55
Code: LC-57
Size: 29 x 22" (73.7 x 56 cm)
For LC-66
Code: LC-67
Size: 33 x 26" (84 x 66 cm)
For LC-88
Code: LC-87
Size: 39 x 32" (99 x 81.3 cm
Light Controls
Fabric Egg Crates
For better light control. Each Egg
Crate attaches quickly and
afterwards folds
up to be
stored in
its own
small
light-
weight
bag.
30° x 30° Egg Crate
Fabric Egg Crate with 30° dispersion
angle.
30° Egg Crate for LC-44
Code: LC-44EC/30
Weight: 8 oz (228 g)
30° Egg Crate for LC-55
Code: LC-55EC/30
Weight: 9.5 oz (266 g)
30° Egg Crate for LC-66
Code: LC-66EC/30
Weight: 12.5 oz (345 g)
30° Egg Crate for LC-88
Code: LC-88EC/30
Weight: 1 lb (448 g)
40° x 40° Egg Crate
Fabric Egg Crate with 40° dispersion
angle.
40° Egg Crate for LC-44
Code: LC-44EC/40
40° Egg Crate for LC-55
Code: LC-55EC/40
40° Egg Crate for LC-66
Code: LC-66EC/40
40° Egg Crate for LC-88
Code: LC-88EC/40
50° x 50° Egg Crate
Fabric Egg Crate with 50°
dispersion angle.
50° Egg Crate for LC-44
Code: LC-44EC/50
50° Egg Crate for LC-55
Code: LC-55EC/50
50° Egg Crate for LC-66
Code: LC-66EC/50
50° Egg Crate for LC-88
Code: LC-88EC/50
Uni TO Stand
Code: UN-55
Weight: 2.6 lbs
(1.2 kg)
Size: 21.5"
(55.2 cm) folded.
Maximum height:
7' (2.2 m)
Base diameter: 46"
New stand, based on design combi-
nation of Uni-stand & Omni-stand.
More stable than Uni-stand, more
compact than Omni-stand.
For Rifa 44.
KS Jr. Stand
Code: DT-33
Size: Maximum
height: 7'7" (2.3 m),
Collapsed length: 2.3' (65 cm)
Weight: 3.5 lbs (1.6 kg)
Wide based, sturdy, lightweight
stand with 5/8" (1.59 cm)
stud and solid bar legs.
For Rifa 44, 55, 66.
KS Stand
Code: KS
Size: Maximum height:
9' (2.74 m),
Collapsed length:
3' (91 cm)
Weight:
4 lbs
(1.8 kg)
Wide based, sturdier, lightweight
stand with 5/8" (1.59 cm) stud.
For all 4 Rifas.
KSA Stand
Code: KSA
Black-anodized, air-cushioned
stand. Otherwise same as above.
Tota-clamp
Code: T1-30
Weight: 4 oz (113 g)
Clamps onto pipes,
shelves, etc. up to
1 7/8" (4.78 cm) thick.
5/8" (1.59 cm) stud locks in two
positions and accepts a light.
Also accepts two Flexi-shafts with
flags or flectors.
Safety Cable (3)
Code: CM-50
Weight: 2 oz (57 g)
Recommended for extra security
when attaching Rifa-lites overhead.
(Set of 3).
Balance Bar
Code: LC-30
Size: 12.5" (31.8 cm)
Weight: 6.5 oz (184 g)
The Rifa Balance Bar is an extension
arm accessory that mounts between
the Rifa-lite and its stand fitting.
When installed, it can shift the Rifa’s
center of gravity to allow better stand
balance. It can facilitate angling and
tilting of the light when necessary,
such as on a boom arm, without the
need to overtighten stand fitting
knob. Install Balance Bar as shown,
orienting conical washers as
shown (
* ).
Mounts
16' Switched AC Cable
Code: T1-80
Weight: 13 oz (369 g)
Standard #18/3; with switch.
10' Unswitched Cable
Code: T1-808
Weight: 1.1 lbs (.5 kg)
For portable stage lighting use.
“Hard service” #18/3 cable.
16' (5 m) Eurocord
Code: T1-801
Weight: 13 oz (369 g)
#18/3 (.75 mm/3) with double pole
switch and male CEE-7 plug.
16' (5 m) T/O UK Cord
Code: T1-802
Weight: 13 oz (369 g)
#18/3 (.75 mm/3) with double
pole switch and male fused BS
1363A plug.
5' Omni 30v Cable
Code: O1-81
Adapts Rifa-44 for use with
30 volt battery #18/3; with switch
and 2 pin “Amphenol Type” connec-
tor for batteries.
4-pin XLR Switched Cable
Code: R2-82
Adapts the Rifa-44 or use with
appropriate 12 volt batteries.
No wiring required.
1' 12v Switched Cigarette
Lighter/Car Adaptor Cable
Code: R2-85
Adapts Rifa 44 IEC Connector for
use with some 12 volt batteries and
automobile cigarette lighter sockets.
No wiring required.
12v Car Adaptor
Code: O1-82
Connects T1-80 Cable to cigarette
lighter connector. For Rifa 44 only.
Cables
4
Lowel equipment and kits are sold through authorized Lowel Dealers and, in some countries, Authorized Lowel
Distributors. Repairs, problems, suggestions, and requests for brochures, instructions, parts lists may be handled by
your authorized Lowel Dealer (Distributor) or directly with Lowel. Electrical repairs should be made only by Lowel or a
qualified electrician.
Rifa-lite ® is a registered trademark of Lowel-Light Manufacturing, Inc.U.S. Patent No.
4594645 , ver: 5.0 © Lowel-Light Mfg., Inc. 2005 120
140 58th Street Brooklyn, NY 11220
Call: 800 334-3426 or 718 921-0600
Fax: 718 921-0303
e-mail: [email protected]
www.lowel.com
Problems, info, repairs, etc. Lowel-Light Manufacturing, Inc.
Male
Female
16'
Male Female
16'
Male Female
16'
Female Male
5'
Male
Female
Male
Female
10'
Female Male
1'
Female Male
1'
Rifa Stand-fitting
* Conical
Washers
Rifa
Support
Tube