Tiffen Lowel Blender Original Models - Manual (Page 3)

Accessories Mounts Front Diffusers
Blender comes with
a set of textured
front accessory dif-
fusers that can vary
the light quality, while
diffusing it to help pre-
vent multi-shadows at
close distances. The
standard is Lite Frost.
Also included are
Prismatic, & Cracked
Ice. There are 2 sets
of grooved slots in the
front of the Blender
to hold these.
A clear plastic front
guard is also supplied,
to protect the LED’s.
It should be used in the
slot closest to the
lamps.
Rotate the Diffuser Lock
on top of the Blender
to drop the selected
diffuser into the grooved
drop-in slot on the front
of the unit. Return
DIffuser Lock to closed
position.
Notes: all front
diffusers will lower
output. For smooth-
est effect, Prismatic
Diffuser should be
used with textured
side facing outward.
In addition to stand
mounting, Blender
can be used with the
following:
Handle
& Stud
Code:
ViP-431
Pistol grip
with remov-
able stud
Note: you can
also attach the
Handle direct-
ly to the Blender, with-
out the Stud, by
removing Blender’s
Stand Fitting and
screwing the handle
into the 1/4-20 thread
on the underside of
the Accessory Slot.
Cam-link
& Stud-link
Code:
ViP-41S
For mounting
on camera
shoe.
Accessory
Slot
for Gel frame
or umbrella
To use a
Tota-brella or
iP Gel Frame
with Blender,
attach securely using
Accessory Slot &
Locking Knob.
Remove textured front
accessory for added
output.
Lite Frost
Prismatic
Cracked Ice
Textured
Front
Accessory
Diffusers