Thermon ZP-R-WP - Manual (Page 3)

3
2.
Mount expediter to bracket using M5 x 8
mm screws and M5 lock washers.
3.
Cut end of cable at angle to aid in piercing
grommet. Leave additional cable for
expansion as needed. Slide insulation
entry kit (if applicable) over the cable.
4.
Insert cable into expeditor.
5.
Cut off end of cable.
6.
Terminate cable with appropriate PETK
termination kit. Refer to PETK installation
instructions.
8.
Mount junction box base on expediter.
Make sure to align slots to properly
orient junction box base. Tighten nut
with Terminator-LN-Tool. If mounting
horizontally, threaded gland holes must
face downward.
Terminator
TM
ZP-R-WP
INSTALLATION PROCEDURES
1a.
Mounting Method 1: Secure wall mount
bracket to mounting surface using pipe
band provided with kits.
1b.
Mounting Method 2: Secure wall mount
bracket to mounting surface using
customer supplied screws, flat washers,
and nuts.
7.
Push excess cable back through
expediter. Tighten cap securely. Tape
cable expansion loop to pipe.