Thermon ZP-XP Terminator - Manual (Page 5)

5
Locate bus connection (HPT and FP only) and
cable as shown. Cut end of cable at angle to
aid in piercing grommet. Leave additional cable
for expansion loop.
Two Cable Layout Tips
Insert two cables into expediter.
Note: For HPT and FP cable, exchange
grommet in Terminator with GRW-G provided
in PETK-3.
Power Connection (1 to 3 Heating Cables)
Three Cable Layout Tips
Locate bus connection (HPT and FP only) and
cable as shown. Cut end of cable at angle to
aid in piercing grommet. Leave additional cable
for expansion loop.
Insert three cables into expediter.
Note: For HPT and FP cable, exchange
grommet in Terminator with GRW-G provided
in PETK-3.
Mount expediter with three cables. Do not
band over cable.
Wiring Details
In-Line Splice and T-Splice End Termination (1 to 2 Heating Cables)
Remove jumpers for 2 cable terminations.
Terminator
TM
ZP-XP
INSTALLATION PROCEDURES
For HPT and FP cable, exchange
grommet in Terminator with GRW-G
provided in PETK-3.
GRW-G