Teletronics 2.4GHz 1 Watt SmartAmp - Manual (Page 9)

Page 8
8. Functioning:
The unit operates automatically and no user adjustments are required.
This amplifier is designed for 2.4 GHz radios using Time Division Duplex (TDD) mode of
operation. It is equipped with a high speed Tx / Rx switch, that detects transmit signal and
switches to transmit mode within 600 ns. In the absence of any transmit signal the unit stays in
receive mode. If used with a radio devices using separate bands for transmit and receive in a
true full duplex mode, the amplifier would not work.
9. Summary:
This manual describes how SmartAmp as a product exploits the automatic gain control by
detecting the input power level, automatically adjusting its gain and maintaining the output
power to a specified level while minimizing the signal distortion and maximizing and
transmission distance. This product has a wide range of wireless applications in Wireless Local
Area Network (WLAN), Wireless Local Loop (WLL), Wireless Internet Access (WIA), wireless
modem connection with point-to-point, point-to-multipoint, where the Time Division Duplex
(TDD) technology is used.
Should you have any problems using it, call our service department at 301-309-8500.
10. Specifications:
Operating Range
2400 ~ 2500 MHz
Operating Mode Bi-directional TDD
Transmit Output Power +30 dBm ( 1Watt )
Transmit Input Power 3 dB min, 23 dB max
Transmit Gain Automatically adjusts up to 26 dB
Receive Gain 16 dB
Frequency Flatness ±1.0 dB
Noise Figure 3.5 dB
Lightening Protection Direct DC ground at antenna port
DC Surge Protection At 9 V DC input
LED indicators on Amp Tx: Green, Rx: Red
Operating Temperature -40 °C ~ + 75 °C
Power Supply 9 V DC at 1.1 Amp
RF Connector Type N, Female
CAUTION: Do not exceed 200mW (+23 dBm) of input power to the amplifier.