Teletronics USB Adapter - Manual (Page 4)

7
3. Windows Installation
The following section will assist you to install Wireless LAN USB successfully. You will
first install software (driver) and then connect the Wireless LAN USB, and finally set
the network properties to accommodate resource sharing and select the type of
wireless network that you wish to install. The Wireless LAN can easily be installed and
used, without bothering to connect cables for keeping your computer to use network
resources, as in case of wired LAN.
Before You Start
Here are some steps you will perform in establishing your wireless network
connection:
• Install the Access Point at first. AP is needed in case of infrastructure
network mode.
• Install the software using the Installation CD Rom
• Install the Wireless LAN USB Dongle
• Install the network protocol(s) required to communicate on your network.
Most likely you will need the TCP/IP protocol.
8
3.1 Installation and Configuration Procedures
Under Windows 98 SE
Please follow the following steps one by one in order to install the WLAN USB
Dongle successfully.
Step 1. Power on your computer and allow Windows 98 SE to load fully. Be sure that
there is no USB dongle is connected to computer yet. Insert the given
Installation CD and then double click the MY Computer icon on your deskto p .
In my computer window, double click the CD Drive icon. In CD Drive, double
click Software , in the software folder, double click to execute Setup.exe, then
Click Next to continue.