Teletronics VERSA - Manual (Page 2)

Quick Setup Guide
I. Initial Setup
Requirements
-One or more PCs (desktop or notebook) with Ethernet interface.
-TCP/IP protocol must be installed on all PCs. (Refer to User Manual for additional information)
-Network cables. Use standard 10/100BaseT network (UTP) cables with RJ45 connectors.
-All wireless devices must be compliant with the IEEE 802.11B specifications.
-Microsoft Internet Explorer 5.0 or later or Netscape Navigator 4.7 or later.
* To avoid damage to the EZ Bridge, do not connect the power adapter to a power source
until all other connections has been established.
II. Unit login info
After all initial setup requirements are checked type the following IP under
the address bar of a web browser to login.
VERSA Router Default IPs
Address = https://192.168.1.1
Authentication
User Name: admin
Password: 1234
Enclosure: Waterproof
Dimensions: (PCB): 6.4" x 5.2" x 0.7"
Enclosure Dimensions Outside:
7.5" x 9" x 2.75"
Enclosure Dimensions Inside:
7" x 7.5" x 2"
Operating Temperature: -10 ~ 60
° C
(14~140 ° F)
Humidity (non condensing): 5 ~ 80%
Weight: 3.51lbs (Box, Board, Adaptor
Cable, AC Adaptor, DC Injector,
RJ-45) (PCB 0.7lb)
*Part pictures will vary, please use it only for general guide line.
Re-using items (1) and (2) from the safety cap, assemble the waterproof RJ-45
connector as shown below:
NEMA 4 Enclosure
Safety Cap
2 1
2
3 1 4
5
6
Waterproof RJ-45
Connector Assembly
Assembly Instruction
PLEASE VISIT OUR WEBSITE AT WWW.TELETRONICS.COM FOR MORE INFORMATION
Default Factory Settings
Ethernet interface IP: 192.168.1.1
WLAN interface IP: 192.168.2.1
Wireless Mode: Access Point and ESSID: DEFAULT
Note: For a back-to-back connection between the CPE unit and any Network
Interface Card using a crossover cable, please use 10M or 100M Half Duplex
fix speed rate. Some cards do not Auto Sense or Auto Negotiates properly
with the NIC card in the unit.