Tech Source GFX 550e - Manual (Page 22)

GFX 550e Installation and Reference Manual
4-2
If the directory does not exist, type:
prompt# mkdir /etc/dt/config
prompt# cp /usr/dt/config/Xservers \
/etc/dt/config
The sample
Xservers.mko
file which is provided, assumes
that the GFX 550e card is the only framebuffer on which to start
CDE:
:0 Local local_uid@console root \
/usr/openwin/bin/Xsun :0 –dev \
/dev/fbs/mko0 –nobanner
You may add any other desired command line arguments to the
end of this line. For example, you may start CDE on multiple
displays. To do this, list each display device following the
convention above.
The following configuration displays CDE on the display named
/dev/fbs/mko0
and uses the device named
/dev/fbs/m640
as a secondary framebuffer:
:0 Local local_uid@console root \
/usr/openwin/bin/Xsun :0 –dev /dev/fbs/mko0 \
-dev /dev/fbs/m640 –nobanner
NOTE: If the name of your GFX 550e device is something
other than
mko0
, please substitute the correct name in the file.