Tech Source GFX 550e - Manual (Page 12)

GFX 550e Installation and Reference Manual
3-2
The following are prerequisites for installing the “GFX 550e
Driver Software”:
• The system is running Solaris 10 or higher..
• At least 2MB of disk space is available in "
/usr
" and “
/
.”
• One or more GFX 550e cards are presently installed in the
desktop/server.
NOTE: All device drivers are loadable. No kernel changes are
required.
3.3 Installing GFX 550e Driver Software
This section describes software installation from a CD-ROM.
3.3.1 CD-ROM Installation
The following are step-by-step instructions for installing the “GFX
550e Driver Software” from a CD-ROM.
1.
Install a GFX 550e card in the computer as described in
Chapter 2.
2.
Boot the computer with the "
-r
" (reconfiguration) option.
To do this on a typical SPARC desktop/server, perform
the following steps:
• Power ON the computer.
• Wait until you see boot messages displaying on the
screen, then press and hold the
Stop
(L1) key, and
then press the "
A
" key.
• At the "
ok
" prompt, type "
boot –r
" followed by the
key
.
3. After the system has booted, log in as
root
.
4.
Insert the CD-ROM labeled "GFX 550e Driver Software-
Solaris Edition" into the CD-ROM drive.