Tech Source Raptor Drivers for HP-UX - Manual (Page 22)

Raptor Drivers for HP-UX Installation and Reference Manual
4-2
#Screen /dev/crt
Screen /dev/raptor0
4.2.2 Multi-Screen Mode
To run X Windows on the console and the Raptor card, list the
devices in the order you wish to register them with X. The first device
listed will be screen :0.0; the next, screen :0.1.
Screen /dev/crt
Screen /dev/raptor0
X Windows can also be run on two Raptor cards. For example to set
up Raptor 2000 as screen 0 and Raptor 1100T as screen 1
(display0) edit the X0screens file as follows:
Screen /dev/raptor0
Screen /dev/rap1kt0
NOTE: Multi-screen mode can be used on multiple Raptor cards only
if the cards are not of the same type.
4.3 Setting Bit-Depth and Resolution
4.3.1 Setting Bit-Depth
The Raptor 2000 supports 8-bit PseudoColor mode only. Raptor
1100T, Raptor 2100T and Raptor 2500T support the following bit-
depths:
8 8-bit PseudoColor
24 24-bit TrueColor
8+24 Simultaneous 8-bit PseudoColor and 24-bit
TrueColor