Tech Source Raptor Drivers for HP-UX User Manual
Page 14

Raptor Drivers for HP-UX Installation and Reference Manual
3-2
3.2.1 Installation on HP-UX 10.20
The following are step-by-step instructions for installing the Raptor
Drivers for HP-UX 10.20 software from a CD-ROM.
1. Install a supported Raptor card in the HP workstation/server, and
boot the system.
2. Log in as root on the target system, using /sbin/sh as your
shell.
3. Uninstall any previous version of Raptor software in accordance
with the instructions supplied with that software.
4. Insert the CD-ROM labeled “Raptor Drivers for HP-UX" into the
drive.
5. Run swinstall. Accept all the path defaults.
6. The swinstall program will automatically try to locate, mount,
and read any CD-ROM device present. If the program is
successful, it will display TSIRDHPUX_10 and TSIFTHPUX_10.
If this is not displayed, please proceed to the section titled,
“Mounting the CD-ROM Manually.” See Section 3.2.4.
7. Move the cursor down to the desired package and highlight it by
pressing
NOTE: You only need to install the packages for the graphics card
that you wish to use.
8. Press
to 'Actions' and press
'Install (analysis)' and press