Tech Source Raptor Drivers for HP-UX - Manual (Page 18)

Raptor Drivers for HP-UX Installation and Reference Manual
3-6
(Replace /dev/dsk/c1t2d0 with your device file from step 3.)
5. Verify that you can read the CD-ROM.
# ls /CD-ROM
6. Initiate "swinstall" and specify your mount point as the
source depot.
# swinstall -s /CD-ROM
7. Move the cursor down to the desired package and highlight it by
pressing .
8. Press to activate the menu bar. Move the cursor across
to 'Actions' and press . Move the cursor down to
'Install (analysis)' and press .
9. Follow the on-screen instructions to complete installation. If any
warnings or errors are reported, check the Log file (default:
/var/adm/sw/swagent.log
), correct the errors, then
continue.
3.3 New Devices
One new device name is created in the /dev directory for each
Raptor card. It is denoted by raptor# for the Raptor 2000 card,
where # represents an instance number assigned by the operating
system. The device names for the other products are enumerated
below:
Raptor 2100T rap2kt#
Raptor 2500T-DL raptfp#
Raptor 1100T raplkt#
If the Raptor card was not present in the system during software