DigiTech RP300A - Manual (Page 25)

V-Switch Sensitivity
If you wish to adjust the sensitivity setting of the V-Switch, follow steps 1 through 7 for
Calibrating the Expression Pedal and then follow the steps listed below:
1. When the Display reads
VSWTCH, rock the Expression Pedal forward (toe down) and
apply extra pressure on the toe of the Pedal until the Display reads DONE.
2. The Display now alternates between showing DONE (with the V-Switch sensitivity value in
the numeric Display) and VSWTCHOn (or VSWTCHOf depending on whether the V-Switch is
on or off). You can audition the V-Switch sensitivity by applying pressure to the toe of the
Expression Pedal.
3. Rotate the Number 5 Knob to change the value of the V-Switch sensitivity. You can audi-
tion the new value again by applying pressure to the toe of the Expression Pedal.
4. Once the desired sensitivity value is selected, press any Footswitch. The RP300A will
return to Performance Mode and your settings are automatically saved.
21