DigiTech RP300A - Manual (Page 10)

About the RP300A
The Presets
Presets are named and numbered locations of programmed sounds which reside in the
RP300A. Presets are recalled with the Footswitches. The active effects in each Preset will be
indicated by the lighted LEDs in the Effect Matrix. The RP300A comes with 40 User Presets
(Presets U1-U40), 40 Factory Artist Presets (Presets A1-A40), and 40 DigiTech factory presets
(F1-F40). The User Presets are locations where your creations may be stored. The
Artist/Factory Presets will not allow you to store any changes to them. From the factory, the
40 User Presets are exact duplicates of the 40 Factory Artist Presets. This allows you to
create your own Presets without the worry of losing the sounds that came with the RP300A.
Performance Mode
When you first apply power to the RP300A, it will power up in Performance mode.
Performance mode provides access to all of the Presets within the RP300A via the Up and
Down Footswitches. The Number 1 Knob (left) will adjust the Gain for the selected Amp
Type, the Number 2 Knob (second from the left) will adjust the amount of Bass
enhancement, the Number 3 Knob (middle) will adjust the amount of Mid-range
enhancement, the Number 4 Knob (second from the right) will adjust the amount of Treble
(high frequency) enhancement, and the Number 5 Knob (right) will adjust the Master Level
(volume).
Bypass Mode
The RP300A Presets can be bypassed for a clean, unprocessed guitar tone. To bypass the
RP300A, press both the Up and Down Footswitches simultaneously. The Display will read
Bypass indicating the Preset is bypassed. Pressing any of the 3 Footswitches will exit
Bypass and return the RP300A to the previously selected Preset.
Tuner Mode
The Tuner in the RP300A allows you to quickly tune or check the tuning on your guitar. Enter
Tuner mode by pressing and holding the Up and Down Footswitches simultaneously. The
Display will briefly show
TUNER indicating that you are in Tuner mode. To begin tuning, play a
note on your guitar (a harmonic at the 12th fret usually works best). The right 2 characters in
the Display will show the note being played. The left characters in the Display indicate
whether you are sharp or flat. Arrows pointing to the left (
<<<) indicate the note is sharp and
should be tuned down. Arrows pointing to the right ( >>>) indicate the note is flat and should
be tuned up.When the note is in tune, the Display will show TUNED.
In Tuner mode, you can change your tuning reference. The default factory setting is A=440 Hz.
(displayed as
A=440). Rotating the Number 1 Knob will select alternate dropped tunings.
Alternate tunings are A = Ab , A = G , and A = Gb. The display window will briefly flash the
currently selected tuning preference.
The output is muted in Tuner mode. The Expression Pedal will unmute the output allowing
signal to be heard while tuning. Exit tuner mode by pressing any of the 3 Footswitches.
>>><<< A
6