DigiTech RP300A User Manual
Page 18
Parameter 2 - The Number 3 Knob adjusts the strength the signal must be (Sensitivity) in
order to trigger the Flanger. Ranges from
1 (requiring strong signals to
trigger) to
99 (triggers with weak signals).
Parameter 3 - The Number 4 Knob selects the point at where the Flanger will begin it’s
sweep (LFO Start). Ranges from
0 to 99.
Mod Level - The Number 5 Knob controls the mix of wet and dry signal. Ranges from
0
(all dry) to
99 (all wet).
Phaser (
PHaseR)
A Phaser splits the incoming signal, and then changes the phasing of the signal. This signal is
then taken in and out of phase and mixed back in with the original signal. As the phasing
changes, different frequencies get canceled resulting in a warm sort of twisting sound.
Parameter 1 - The Number 2 Knob adjusts the rate (Speed) of the modulating phase.
Ranges from
1 to 99.
Parameter 2 - The Number 3 Knob adjusts the intensity (Depth) of the modulation.
Ranges from
1 to 99.
Parameter 3 - The Number 4 Knob adjusts the amount of effected signal returned to the
input of the Phaser (Regeneration). Ranges from
1 to 99.
Mod Level - The Number 5 Knob controls the mix of wet and dry signal. Ranges from
0
(all dry) to
99 (all wet).
Triggered Phaser (
TRGPHA)
A Triggered Phaser is the same sound as a regular Phaser but allows you to choose the
starting point of the Phaser sweep. In a regular Phaser, the low frequency oscillator (LFO) is
continually changing the phase of the signal. This means that when you begin to play, the phaser
may be at the any random point of the phase. With a Triggered Phaser, every time the signal
exceeds the Sensitivity level setting, the Phaser will begin at the point of phasing that you
designate with the value of the LFO Start Parameter.
Parameter 1 - The Number 2 Knob adjusts the rate (Speed) of the modulating phase.
Ranges from
1 to 99.
Parameter 2 - The Number 3 Knob adjusts the strength the signal must be (Sensitivity) in
order to trigger the Phaser. Ranges from
1 (requiring strong signals to
trigger) to
99 (triggers with weak signals).
Parameter 3 - The Number 4 Knob selects the point at where the Phaser will begin it’s
sweep (LFO Start). Ranges from
0 to 99.
Mod Level - The Number 5 Knob controls the mix of wet and dry signal. Ranges from
0
(all dry) to
99 (all wet).
Tremolo (
TREMLO)
A Tremolo effect modulates the volume of the signal at an even rate.
Parameter 1 - The Number 2 Knob adjusts the rate (Speed) at which the volume
modulates. Ranges from
1 to 99.
Parameter 2 - The Number 3 Knob adjusts the intensity (Depth) of the modulating
volume. Ranges from
0 to 99.
The Number 4 and 5 knobs have no function when the Tremolo is selected.
Panner (
PANNER)
An Auto Panner modulates the sound from left to right at an even rate.
Parameter 1 - The Number 2 Knob adjusts the rate (Speed) at which the signal pans from
side to side. Ranges from
1 to 99.
Parameter 2 - The Number 3 Knob adjusts the intensity (Depth) of the changing pan.
Ranges from
0 to 99.
The Number 4 and 5 knobs have no function when the Panner is selected.
14