Teac MD-CD1 - Manual (Page 26)

7 – CD and MD Playback—Time Search function
26
TASCAM MD-CD1 Owner’s Manual
Time Search function
By specifying time from the start of a certain track,
you can start playback from a specified point of a
specified track.
Basic operation
1 During stop, play or playback standby
modes, use the number keys on the remote
control to input the three-digit track number
(such as 002 for track 2), then the desired
elapsed time (***min **sec) from the start of
that track.
Example: To specify 1 min 30 sec from the
start of track 2, input “002 001 30”
NOTE
For MP3 discs, time cannot be specified within a track.
However, if you input the three-digit track number,
playback will begin from the start of that track.
During input, the counter in the display will flash.
Regardless of the time display mode, the time from the
start of the specified track is displayed.
When the final digit is entered, the desired
position is automatically located. During stop
or playback modes, playback will begin from
the desired point. During playback standby
mode, at the desired point the unit will enter
playback standby mode.
NOTE
If a point which does not exist is selected, setting opera-
tion will be cancelled.
Operation variations
Even if the final second is not input, playback will
begin from the selected point after pressing the
PLAY key. Or, if you press the READY key, the unit
will enter the playback standby mode at the selected
point.
Track search
This is explained in the “Specifying by track num-
ber” part of “Track selection” on page 25.
After inputting the three-digit track number, press the
PLAY key to begin playback of that track, or the
READY key to cue the track and enter playback
standby mode.
Specifying to the minute
After inputting the three-digit track number and the
number of minutes after the start of the track, press
the PLAY key to begin playback of that track, or the
READY key to cue the track and enter playback
standby mode.
Example: To specify 1 min 00 sec from the start of
track 2, input “002 001”
NOTE
Following the above example, if “0021” is input, the
same position will be located.
Auto cue
When the auto cue function is turned on, when a
track is selected, the point where sound begins (not
where the track begins) on that track is located, and
the unit enters playback standby mode. Then, when
the PLAY key is pressed, playback begins at exactly
that point.
Auto cue on/off and the sound start position detec-
tion level can be set separately for CD and MD.
NOTE
Auto Cue functions only for MD tracks recorded in the
ST mode. For MD tracks recorded in MONO, LP2 or LP4
modes, the Auto Cue function will only cue to the very
beginning of the track.
NOTE
During the stop mode, to cue to the start of sound on
track one, just press the READY key.
Turning the Auto Cue function on and off
Press the AUTO CUE key on the remote control to
turn this function on and off.
You can also use the “A_CUE?” option on the PLAY
sub-menu of the MD menu or CD menu to turn the
2ReMD-CD1.fm 26 ページ ２００４年１１月５日 金曜日 午前７時３５分