Teac CD-RW890 - Manual (Page 3)

3
WARNING: TO PREVENT FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE.
CAUTION
DO NOT REMOVE THE EXTERNAL CASES OR CABINETS TO EXPOSE <
THE ELECTRONICS. NO USER SERVICEABLE PARTS ARE WITHIN.
IF YOU ARE EXPERIENCING PROBLEMS WITH THIS PRODUCT, <
CONTACT TEAC FOR A SERVICE REFERRAL. DO NOT USE THE
PRODUCT UNTIL IT HAS BEEN REPAIRED.
USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF
<
PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT
IN HAZARDOUS RADIATION EXPOSURE.
For U.S.A.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protec tion against harmful inter ference in a residential
installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the equipment and/or the receiving <
antenna.
Increase the separation between the equipment and receiver.
<
Connect the equipment into an outlet on a circuit different
<
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
<
help.
CAUTION
Changes or modifications to this equipments not expressly
approved by TEAC CORPORATION for compliance will void the
user’s warranty.
This product has been designed and manufactured according to
FDA regulations “title 21, CFR, chapter 1, subchapter J, based on the
Radiation Control for Health and Safety Act of 1968“, and is classified
as class 1 laser product. There is not hazardous invisible laser
radiation during operation because invisible laser radiation emitted
inside of this product is completely confined in the protective
housings.
The label required in this regulation is shown
{.
Optical pickup :
Type: SF-DS1XD
Manufacturer: SANYO ELECTRIC CO., LTD.
Laser output: Less than 1.6 mW (Play) on the objective lens
Less than 47 mW (Record) on the objective lens
Less than 13 mW (Erase) on the objective lens
Wavelength: 785 nm
{ For U.S.A.
CLASS II apparatus with double insulation, and no protective
earth provided.
CD-RW890_E_vA_unlocked.pdf 3 10/09/08 17:17