Teac CD-RW890 - Manual (Page 24)

24
Erasing All Tracks In Refresh Mode (CD-RW)
3 Press the Play (
y) button to start erasing.
All tracks will be erased.
The time required appears on the display.
When the operation has been finished, the display returns to the
track/time display.
Never turn the power off nor unplug the power cord during <
erasing.
During erasing, no buttons will work. <
This operation cannot be undone. Before erasing the tracks, make
<
sure that you really want to erase them.
ERASE #
ERASE DISC
REFRESH
ERASE DISC
REFRESH
Erasing in the refresh mode takes time. It is recommended to use
“ERASE DISC” when erasing all tracks.
A disc that causes an error during recording may be recovered by
erasing all tracks on the disc in the refresh mode.
1 Load a recorded CD-RW.
2 Press the ERASE button three times.
“REFRESH” appears on the display.
Each time the ERASE button is pressed, the display changes as <
follows:
If only one track is recorded, “ERASE” and the last track number do
<
not appear. The display changes in the following order:
Press the Stop ( < H) button to stop erasing if you need.
If a finalized disc is inserted, “UNFINALIZE” appears. To erase the
<
track(s), unfinalize the disc first.
(#: The last track number)
Total number of tracks and total playback time
Total number of tracks and total playback time
CD-RW890_E_vA_unlocked.pdf 24 10/09/08 17:17