TE Technology TC-24-25 - Manual (Page 29)

29
Interpret: Value to offset Input2 by in order to calibrate external
sensor if desired.
25. ALARM LATCH ENABLE
Write Command: 2f hex
Read Command: 48 hex
Interpret: 1 is latching enabled.
0 is latching disabled.
If Alarm Type is equal to 3 then
1 is Computer Alarm On.
0 is Computer Alarm Off.
26. CONTROL TIMEBASE
Write Command: 30 hex
Read Command: 49 hex
Interpret: Setting of 0 is 675 Hz timebase.
Setting of 1 is 2700 Hz timebase.
27. ALARM LATCH RESET
Write Command: 33 hex
Read Command: NA
Interpret: Send this command to reset the alarm latches.
28. HEAT MULTIPLIER
Write Command: 0c hex
Read Command: 5c hex
Interpret: This multiplies the heater percentage of power to offset its
effectiveness.
100 is a multiplier of 1.00
1 is a multiplier of 0.01
29. CHOOSE SENSOR FOR ALARM FUNCTION
Write Command: 31 hex
Read Command: 4a hex
Interpret: 0 is for the Control Sensor Input.
1 is for the Input2 Secondary Input.
30. CHOOSE °C or °F TEMPERATURE WORKING UNITS
Write Command: 32 hex
Read Command: 4b hex
Interpret: 0 is °F
1 is °C