Swim'n Play Slim Style Oval Pool - Manual (Page 19)

19
Measure from the last
strap to the outer end
of the pool.
Measurements in both ends
should be equal. Also make
sure that the sides of the
pool between the straps
are straight.
Confirm that the strap
assemblies are "square"
by measuring diagonally
across from the first strap
to the last strap.
Make sure that the Support
Posts on each side of the pool
are lined up in a straight row.
POOL WALL VIEWED FROM
ABOVE
48” 48” 48”
48” 48” 48”
Also, the measurements from the center of one strap to the center of the next one should be 48".
Fill the trenches and all open areas in
and around the Bottom Supports with
screened damp earth or pre-washed sand.
3 LAYERS
OF TAPE
CLOTH TAPE
OR DUCT TAPE
VIEW FROM
INSIDE OF POOL
WALL
SEAM
SKIMMER
INLET FITTING
SKIMMER
RETURN FITTING
Once the wall is closed and screws and nuts are tight-
ened securely, cover the screw heads on the inside of
the pool with 3 layers of cloth tape all the way from top
to bottom of wall. If the filter inlet and outlet are not
used, cover over the pre-scored areas on the inside
of the pool wall with 1 layer of tape.
I f y o u r P o o l Wa l l h a s t h e
Recessed Posi-Lock System an
additional layer of tape should
be added to the inside part of the
extended end of the wall.
Cloth tape or duct tape is
available through your local
pool dealer or hardware
store.
3 LAYERS
OF TAPE
INSIDE OF
POOL VIEW
INSIDE OF
POOL VIEW
WALL
SEAM
EXTENDED
END OF WALL