Swim'n Play Slim Style Oval Pool - Manual (Page 16)

16
Follow the instructions below to properly layout the rail and strap assemblies.
QUANTITIES NEEDED:
POOL SIZE 18x12 20x12 24x12 24x15 30x15 33x18 39x18 45x18
STRAP ASSEMBLIES 2 2 3 3 4 4 6 7
45½” RAILS 2 2 4 4 6 6 10 12
STANDARD RAILS 8 8 8 8 8 10 10 10
BOTTOM PLATES 10 10 10 10 10 12 12 12
TRANSITION RAILS 4 4 4 4 4 4 4 4
EXAMPLE OF BASIC LAYOUT
Patio Block
Bottom Plate
Transition
Rail
Transition
Rail
Strap Assembly
45½”
Straight Side Bottom Rails
Standard
Bottom Rail
Standard
Bottom
Rail
45½”
Bottom Rail
Ground Shield
(Optional)
Transition
Rail
Transition
Rail
Mark out pool radius (1/2 pool width) using stakes "B"
as a reference. Form the two end semicircles by sliding
the long bottom rail groove up, into the bottom plates. Lay
out the strap assemblies as shown removing the stakes
as you go. The distance from strap to strap is 48". Install
the short bottom rail in between each strap
as shown. All rails are curved, including the 45½”
used on the straight side.
Bring the required amount of sifted earth or pre-washed
sand into the pool area at this time. Refer to chart above
for the required minimum amount. Place patio blocks
under all bottom plates and end of strap assemblies.
Follow the diagram below to setup
your specific pool size:
Inside Pool
48”
PRE WASHED SAND OR
SIFTED EARTH RECOMMENDED
REQUIREMENT CHART
POOL SIZE TONS YARDS
18’ x 12’ 2.4 Tons 1.6 Cu.
20’ x 12’ 2.7 Tons 1.8 Cu.
24’ x 12’ 3.3 Tons 2.2 Cu.
24’ x 15’ 3.8 Tons 2.5 Cu.
30’ x 15’ 4.8 Tons 3.2 Cu.
33’ x 18’ 6.0 Tons 4.0 Cu.
39’ x 18’ 7.2 Tons 4.8 Cu.
45’ x 18’ 8.3 Tons 5.5 Cu.