SVS COLUMN LIFT - Manual (Page 7)

the Two Button switch for external control. For wiring suggestions see External Wiring Options 1
and 2 in Section 9.
The TMD Relay Accessory provides the connections to the TMD Two Button switch as well as the
relays and DC power supply for connecting to external controllers or customer supplied switch. If
you TMD was ordered with this accessory, for wiring details see TMD-RY Wiring in Section 9.
For touch screen controllers (AMX/Crestron), use voltage from the touch screen controllers to
energize the relays. The maximum wiring length from the microprocessor control unit to the
external control relay or switch cannot exceed 6 foot. For wiring suggestions see Touch Screen
Wiring Options 1 and 2 in Section 9.
7. Mounting Screens
After checking the lift operation and all clearances, the screen can be installed. Raise the lift.
Remove the Screen Mount Adapter Brace from the lift by removing the five bolts holding it to the
telescoping column. See the Column Dimension drawing for the location of the Screen Mount
Brace Adapter. Use the Mount Adapter Brace as a template to drill two or three ¼ - inch holes in
your screen mount aligned with the two or three upper holes in the adapter. The holes in the Mount
Adapter Brace are spaced 4 ½ - inches apart. The holes on your screen mount should be centered
horizontally so that your screen will be balanced from right to left on the lift. Your screen mount
should be placed vertically so that to top of your screen is level with the top of the Column
telescoping column. If this is not possible, mount your screen as low as practical on the telescoping
column. Re-attach the Mount Adapter Brace to the telescoping column using the bottom two bolts.
Use the three top bolts to attach your screen mount to the Mount Adapter Brace and the Column
telescoping column. Follow the screen mount instructions for mounting the screen to the screen
mount. Once the screen is mounted to the Column lift slowly lower the lift carefully. Check all
clearances as the lift and screen are lowered. Ensure that the closure panel fits securely into the
furniture top.
8. Cable Management
Video, Audio, Power Cable can be attached to the inside of the furniture with a service loop behind
the telescoping column. Keep the cables away from moving parts. See the Column Cable
Management Drawing in Section 9.
9. Drawings and Schematics