beautypg.com

Warning – SVS COLUMN LIFT User Manual

Page 5

background image


The SVS Column Lift can be used with a variety of plasma/LCD screens and installed into various
pieces of furniture; there are no specific instructions for installing the Column lift.

Please use the

following guidelines.

Uncrate the Lift

§ Remove the Column Lift crate top. (The Column Lift should be transported in a horizontal

position to prevent damage to the lift.)

§ Carefully remove the packing material and lift restrains from around the lift.

§ Carefully remove the lift.

§ Please retain all packing material until installation is complete.

The Column consist of:

§ Telescoping Column (with Microprocessor control unit)

§ Two button control switch (with 1.5-meter cord)

§ Installation Instruction Package

Lift Accessories may be shipping separately.

WARNING


DO NOT disconnect the telescoping column unit from the microprocessor control unit while
the telescoping column is at its end stops (fully extended or fully retracted).

Testing the SVS Column Lift

Step 1. Connect the 1.5 Meter two button control switch to the 7-pin plug to the port labeled "HS"

on the microprocessor control unit attached to the telescoping column.


Step 2. Supply power to the Lift. Connect the power cord from the microprocessor control unit to a

suitable 110 VAC outlet.


Step 3. The Column Lift is now controllable with the two-button control switch. Ensure that the

Column lift will open to it full height and retract to its closed position.


Mounting the lift

§ Mount the column to the inside of your cabinet using the four 3/8-inch mounting holes. See the

Column Dimension drawing in Section 9.

§ The lift should be mounted so that the your closure panel will be even with your furniture top

with the lift in the lowered position.

§ Mount the two-button switch in a convenient location to control the lift and allow the 1.5-meter

two-button switch cord to connect to the microprocessor control unit.