SVS PLASMA ONE 7 - Manual (Page 9)

Figure 7
The Main Support is pre-drilled for one of the cross framework (the upper one). This distance is set for
all Plasma Display sizes to avoid contact between the plasma display and the up microswitch bracket of
the lift. Do not adjust bracket to extend the plasma display beyond this point. Attach the upper end of
the Support Framework by matching the two (2) countersink holes and installing the (2) 10/32" flathead
screws provided. After installing the upper end of the Support Frame, the lower end can be drilled,
countersunk and fastened to the Main Support using the other (2) 10/32" flathead screws. If the main
support (4”x 3/8”) extends beyond the lower tube of the Framework, it can be cut to reduce the ceiling
opening size.
Step 2: After aligning the framework, the ceiling closure material can be attached by drilling and tapping
into the square tubing for the 8/32 flathead machine screws. At the two ends of the hinge mounting holes,
insert two (2) more 8/32 screws into the Tinerman nuts -see Figures 8a and 8c. Removing all 8/32 screws
will provide access to the lift is in a closed position. Any type of material can be used for the closure,
including aluminum plate, plastic sheet, wood, reinforced plaster board, or any other rigid material.
With an aluminum spacer, attach the hinge to the Main Support using (3) 10/32" Allen Head screws and
nylon lock nuts – figure 8b.
SVS, Inc. does not supply the closure panel. The ceiling closure material can be countersunk with the
screws made flush with ceiling material.
SVS PLASMA LIFT INSTALLATION PAGE 9 OF 16
CEILING CLOSURE
INSTALLATION
LIFT POSITION
(REFERENCE
ONLY)
10/32" FLATHEAD SCREW
(4) PLACES HEXNUTS UP
DRILL AND INSTALL (4)
1/8" POP RIVETS OR
SCREWS IN EACH
INSIDE CORNER.
CUT ALL CORNERS
AT 45 deg.
SPECIAL TOOLS NEEDED
1/8"and 3/16" drill
countersink
pop rivet gun
8/32 tap,#29 drill
VIEW FROM TOP
ANGLE SUPPORT
INSIDE TUBING
31.88" MIN.
CLOSURE LIFTING
ADJUSTABLE ARMS.
1/4" BOLTS TO MAIN SUPPORT
3/8" TO LIFTING ARMS.
MAIN SUPPORT
10/32 FLATHEAD SCREW
AND NUTS
CROSS FRAMEWORKS
END
FRAMWORKS
8/32 T NUT FOR
CLOSURE PLATE
27.32"