SVS 7 110V - Manual (Page 14)

b. Accessory #7 Cable Retractor
Accessory #7 Cable Retractor is standard equipment on SVS
7-15, SVS 7-18, SVS 7-20, AND SVS 7-22. See Figure 11.
The Cable Retractors are a spring-loaded reel on the rear of
the Lift. The retractor automatically retracts your cable as
the Lift ascends and releases your cable as the Lift descends.
Warning: Over-winding the reel or winding the reel
counter-clockwise will damage the cable reel springs.
Broken cable reel springs are not be cover by the Lifts
warranty.
Instructions:
1. Please read all instructions before installing your
cable on the Cable Retractor cable reel.
2. Lower the Lift to its maximum down position
(Service position).
3. Clamp your cable securely to the outrigger on the
top frame of the Lift.
4. Wind the cable reel clockwise:
 2 ¾ complete turns for the SVS 7-9
 3 ¼ complete turns for the SVS 7-11
 4 complete turns for the SVS 7-13
 4 ½ complete turns for the SVS 7-15
 5 ¼ complete turns for the SVS 7-18
 6 complete turns for the SVS 7-20
 6 ½ complete turns for the SVS 7-22
5. Hold the cable reel in this position to stop the reel
from unwinding.
6. Attach upper half of your cable to the cable reel
between two of the four (4) holes with 3/16” tie-wraps. Leave the tie-wraps semi-loose in case
adjustment is needed.
SVS 7 Lift Installation Instructions Page 14 of 18
Figure 12. Cable Retainer Installation
Figure 13b. Cable Retractor (side view)
Figure 13a. Cable Retractor (inside view)