Code composer, Operating conditions, Safety – Sundance SMT395 User Manual
Page 16: General requirements
Version 1.1.7
Page 16 of 26
SMT395 User Manual
Code Composer
This module is fully compatible with the Code Composer Studio (CCS) debug
environment (version 2.20 or later). This extends to both the software and JTAG
debugging hardware.
The name of the C64xx CCS device driver is tixds64xx_11.dvr, and should be
obtained from Texas Instruments. In case of difficulty please ask assistance via our
.
Operating Conditions
Safety
The module presents no hazard to the user.
EMC
The module is designed to operate within an enclosed host system that provides
adequate EMC shielding. Operation within the EU EMC guidelines is only guaranteed
when the module is installed within an appropriate host system.
The module is protected from damage by fast voltage transients introduced along
output cables from outside the host system.
Short-circuiting any output to ground does not cause the host PC system to lock up
or reboot.
General Requirements
The module must be fixed to a TIM40-compliant carrier board.
The SMT395 TIM is in a range of modules that must be supplied with a 3.3v power
source. In addition to the 5v supply specified in the TIM specification, these new
generation modules require an additional 3.3v supply to be presented on the two
diagonally-opposite TIM mounting holes. The lack of this 3.3v power supply should
not damage the module, although it will obviously be inoperable; prolonged operation
under these circumstances is not recommended.
The SMT395 is compatible with all Sundance TIM carrier boards. It is a 5v tolerant
module, and as such, it may be used in mixed systems with older TIM modules,
carrier boards and I/O modules.
Use of the TIM on SMT327 (cPCI) motherboards may require a firmware upgrade. If
the top right LED on the SMT395 remains illuminated once the TIM is plugged in and
powered up, the SMT327 needs the upgrade. The latest firmware is supplied with all
new boards shipped. Please contact Sundance directly if you have an older board
and need the upgrade.