Sundance SMT9650 - Manual (Page 9)

Document No.
S M T 9 6 5 0 U s e r G u i d e
Revision
3 . 0
Date
2 9 D e c 2 0 0 6
Page
9 of 36
The on-board comport connection between the STM374 and the SMT364 (CP:1 to CP:4) is enabled using
the Sundance BoardInfo utility:
Select Tools and then Comport Switch. This will bring up the following display:
Click the square between TIM1 comport 1 and TIM2 comport 4 to make it display as
...
as in the picture
above, if necessary. This enables the required comport connection. Click OK and then OK again.
The demonstration can be tailored to run on different combinations of hardware modules and carrier
boards by changing parameters in the model, as described in the PARS documentation.