Sundance SMT9650 - Manual (Page 11)

Document No.
S M T 9 6 5 0 U s e r G u i d e
Revision
3 . 0
Date
2 9 D e c 2 0 0 6
Page
11 of 36
1.5 THE PRE-BUILT TASKS
The demonstration uses three PARS pre-built (PB) tasks that have been developed to provide access to
the SMT364 ADC: config364, silo2switch, and chan2mux.
1.5.1. Config364
This PB task configures an SMT364 ADC board. For more information about the SMT364, please refer to
its user manual. This PB task is a wrapper around the Config364 tasks shipped with the SMT6045. For
more information about how the task works and its parameters, please refer to the SMT6045
documentation. This PB tasks takes the following parameters:
Figure 1: Parameters window for Config364 task.
● Place task on: specify which processor this task should be placed on.
● Physical channel from SMT364. Define the physical channel connecting the SMT364 to the
processing board.
● Physical channel to SMT364. Define the physical channel connecting the SMT364 to the
processing board. Normally this is the same as the previous parameter.
● Use default values for ADC. If selected, any parameters entered for ADC registers are ignored
and the default values will be used.
● ADC registers 0 to 4: values for ADC registers. Please refer to the SMT364 User Guide for an
explanation of these registers.