Sundance SMT8091 - Manual (Page 10)

4.2 Hardware Description
The SMT8091 is built around two main modules but also involves a carrier board
and some cables to interconnect them and allow them to communicate with each
other and to access the PC.
⇒ 1x SMT310Q: PCI carrier
⇒ 1x SMT395VP: Single-C6416T based module; to be plugged on site 1 of
SMT310Q.
⇒ 1x SMT391-VP: Dual-ADC module; to be plugged on site 2 of SMT310Q.
⇒ 1x FMS cable (20cm): to connect T1C0 to T2C3 at the back of the
SMT310Q.
⇒ 1x SMT511 (SHB to SHB cable): to connect SHBB (SMT395VP) to SHBB
(SMT391VP).
⇒ 1x SMT516 (SHB to SHB PCB): to connect SHBA (SMT395VP) to SHBA
(SMT391VP).
⇒ 2x MMCX to BNC cables to connect an external analogue signal source to
J1 noted G (ChQ) and to J2 noted C (ChI).
5 Hardware installation
Here are the steps to follow to install the SMT8091 system.
1 – Place the SMT395VP on TIM site 1 of the carrier board (SMT310Q).
2 – The following are then required to mount SMT338-VP+391 on the SMT310Q:
User Manual SMT8091 Last Edited: 15/09/2006 11:54:00