Sundance SMT148FX - Manual (Page 12)

4.1.6 Firewire
A single IEEE1394 interface is provided by an Agere FW801A PHY. The following
table shows the pinout of the connector;
1 Cable Power
2 GND
3 TPB-
4 TPB+
5 TPA-
6 TPA+
This will allow high speed firewire data to be routed directly to the FPGA.
The standard FPGA firmware does not include an IEEE1394 IP core. These
are available from 3
rd parties. Please contact Sundance for further
information.
4.1.7 USB2
The USB2 interface is provided by the Cypress CY7C68013A device.
The Cypress part, in addition to providing USB functions with a FIFO type interface,
also contains a USART, and an 8051 micro-controller.
The USB connector pin-out is shown here;
1 USB_ind
2 Data-
3 Data+
4 GND
The interface provided by this controller looks identical to a 16-bit SDB interface,
and is routed directly to the Spartan FPGA and the CPLD.
The standard Cypress firmware does not include functions to control the
USART. Please contact Sundance for further information.
The following table shows the Cypress pin connectivity to the Sundance SDB signal;
User Manual SMT148FX Page 12 of 48 Last Edited: 03/08/2009 11:42:00