Studio Technologies 76DA V.3.01 - Manual (Page 33)

Model 76DA/77 User Guide Issue 2, April 2011
Studio Technologies, Inc. Page 33
for Surround
Press and hold both the Surround/Stereo and Dim buttons for 5 seconds
to restore Model 77 factory defaults. Once defaults have been restored,
the associated LEDs will light. After the buttons are released, configura-
tion mode will be exited and normal operation will resume.
Configuration—Restore Factory Defaults
Factory Defaults:
Device address A1.
Stereo input C sample rate converter enabled.
Post-fader stereo digital and analog monitor outputs can
be enabled.
Sync source is L/R of currently selected input.
Sync input terminated.
Audio-synced-to-video sample rate 48 kHz.
Pre-fader surround/stereo input C direct digital monitor
output type AES3 (110 ohms/5 Vpp).
Post-fader surround/stereo digital monitor output type
AES3 (110 ohms/5 Vpp).
Reference level set for –60.0 dB post-fader monitor
output level.

Warning: Each Model 77 unit must have a unique address. Restoring factory defaults will reset only this specific
Model 77 to device address A1. If another connected unit is already configured for address A1, normal system
operation will stop.
Note: The 5-second button-press delay is a safety feature ensuring that the factory defaults will not be accidently
restored.
Attenuation display mode selected.
85.0 dB SPL reference level.
Auto reference level off disabled.
–20 dB dim level.
Remote mute all enabled.
Remote dim enabled.
Input delay 0 ms.
LFE downmix disabled.
Pre-fader surround digital monitor outputs pre-downmix.
6.0 dB channel pop solo up offset level.
–6.0 dB channel pop solo down offset level.
0.0 dB post-fader surround monitor output level offsets.
0.0 dB post-fader stereo monitor output level offsets.