Soundtube RS42-EZ - Manual (Page 3)

4. Run signal wire and at
least one safety cable
through conduit.
5. Attach safety cable by first
inserting into side of
mounting bracket.
6. Align safety cable with
center slot and pull up to
secure.
2. Securely mount conduit
to structure. Conduit must
have 3/4” NPT thread to
accomodate RS-EZ speaker.
3. Thread cover plate on to
conduit until secure.
Install Instructions For:
RS-EZ series
7. Connect signal wires to (+)
and (-) inputs. Use extra (+)
and (-) for daisy chaining.
8. Select desired tap position.
Switch is preset to maximum
70.7V (100V) mode.
RS42-EZ, RS62-EZ, RS82-EZ, HP82-EZ
1. Unpack speaker from box.
9. Line speaker up with cover
plate and rotate to lock in to
place. Alignment marks will
meet when secured.
10. Tighten all four (4) screws
to lock speaker in to cover
plate.
11. Done.
Conduit Installation:
1.
2.
1.435.647.9555 | 800.647.TUBE | www.soundtube.com