Soundtube RS42-EZ - Manual (Page 2)

1. Unpack speaker and
SpeedClamp™ mounting
hardware.
2. Thread hanging or safety
cable through SpeedClamp™
mechanisms as shown.
3. Attach the hanging cable
by securing it and safety
cable to structure as shown.
4. Thread cable end(s)
through SpeedClamp™
mechanisms as shown.
9. Connect signal wires to (+)
and (-) inputs. Use extra (+)
and (-) for daisy chaining.
11. Place cover plate onto
top of speaker and rotate
clockwise until alignment
indicators meet.
12. Tighten all four (4) screws
to lock cover plate in place.
5. 7a. Attach hanging cable by
(1) inserting into side of
mounting bracket and (2)
rotating to align with center
slot in hanging bracket.
6. Slide cover plate over
hanging and safety cables
and run signal wire through
center hole.
10. Select desired tap position.
Switch is preset to maximum
70.7V (100V) mode.
7b. Once aligned with central
slot, pull cable up into slot to
secure. Repeat steps 7a and
7b with secondary safety ca-
ble into one of the side slots.
Install Instructions For:
RS-EZ series
Adjust speaker hanging
height with SpeedClamp™
mechanism. Pull to tighten &
press button on SpeedClamp
as shown to loosen or adjust.
13. Install rubber weather
plug by sliding slit over the
wire, then pressing snuggly
into hole in cover plate.
14. Done.
RS42-EZ, RS62-EZ, RS82-EZ, HP82-EZ
8. Extra slot and 2 holes
provided for additional
safety cables where needed.
1.
2.
1.435.647.9555 | 800.647.TUBE | www.soundtube.com