Smithco Super Star 42-00x (sn 4841 – 4984/12712 – 12799) Parts & Service Manual - Manual (Page 115)

113
Accessories
13-298 FAN RAKE ATTACHMENT PARTS LIST
REF# PART# DESCRIPTION QUANTITY
1 13-310 Rake 5
2 13-306 Frame 1
3 HB-38-16-100 Bolt 3 /
8
- 16 x 1 4
HN-38-16 Nut 3 /
8
- 16 4
HWL-38 Lockwasher 3 /
8
4
4 HCP-12-450 Clevis Pin 1 /
2
x 4 1 /
2
1
5 19-107 Drawbar 1
6 HP-18-100 Cotter Pin 1 /
8
x 1 1
7 HCP-12-150 Clevis Pin 1 /
2
x 1 1 /
2
1
HHP-18 Bridge Pin 1 /
8
1
8 13-307 Hitch 2
9 HNCL-14-20 Center Lock Nut 1 /
4
- 20 5
10 HB-14-20-200 Bolt 1 /
4
- 20 x 2 5
INSTALLATION INSTRUCTIONS
1. Remove the complete rake assembly from the trap rake. Replace the clevis pin and bridge pin in the hitch
for future use with the rake.
2. Assemble hitch (Ref 8) to frame (Ref 2) using hardware (Ref 3). Assemble drawbar (Ref 5) to the hitch
using clevis pin (Ref 4) and cotter pin (Ref 6), as shown. The different holes in the hitch are for adjusting
the angle of the rakes.
3. Assemble the five rakes (Ref 1) to the frame using the bolt and center lock nuts (Ref 9 and 10). Slide the
fan rake assembly under the rear of the trap rake to the hitch. Attach the drawbar to the hitch using the
clevis pin and the bridge pin (Ref 7).
4. Hook the chains from the frame to the hooks on the rake lift.
13-319 FAN RAKE KIT PARTS LIST
REF# PART# DESCRIPTION QUANTITY
1 13-326 Left Holder 1
2 13-329 Long Holder 2
3 13-327 Center Holder 1
4 13-328 Right Holder 1
5 29-541 Lock Pin 5
6 13-310 Rake 5
FAN RAKE KIT INSTRUCTIONS
1. Remove connector links that hold rake blades to rake frame if desired.
2. Remove groomer blades from rake frame that are held on with rake teeth studs (Ref A). Replace rake teeth
studs, if desired.
3. Place left holder (Ref 1), angle side up, to the second rake tooth hole from the end and install rake tooth stud.
The first rake tooth hole from each end (Ref B) have no rake teeth in them.
4. Remove the 8th rake tooth stud from the end of right and left rake frame and place long holders (Ref 2) on top,
reinstall rake teeth studs.
5. Remove rake tooth in direct center of rake and install the center holder (Ref 3). Reinstall rake teeth studs.
6. Place right holder (Ref 4), angle side up, to the second rake tooth hole from the end and install rake tooth stud.
The first rake tooth hole from each end (Ref B) have no rake teeth in them.
7. Slide fan rake (Ref 6) onto holders and pin with lock pin (Ref 5).