Smithco Super Rake 13-55х (sn 6201 – 6279/1080 – 1120) Parts & Service Manual - Manual (Page 105)

103
Accessories
13-319 FAN RAKE KIT PARTS LIST
REF# PART# DESCRIPTION QUANTITY
1 13-326 Left Holder 1
2 13-329 Long Holder 2
3 13-327 Center Holder 1
4 13-328 Right Holder 1
5 29-541 Lock Pin 5
6 13-310 Rake 5
FAN RAKE KIT INSTRUCTIONS
1. Remove connector links that hold Rake Blades to rake frame.
2. Remove Groomer Blades from rake frame that are held on with (Ref# A)rake teeth studs. Replace rake
teeth studs.
3. Place (Ref# 1)Left Holder, angle side up, to the outer rake teeth hole and install rake tooth stud.
4. Remove the 8th rake tooth stud from the end of right and left rake frame and place (Ref# 2)Long Holders
on top, reinstall rake teeth studs.
5. Remove rake tooth in direct center of rake and install the (Ref# 3)Center Holder. Reinstall rake teeth
studs.
6. Place (Ref# 4)Right Holder, angle side up, to the outer rake teeth hole and install rake tooth stud.
7. Slide (Ref# 6)Fan Rake onto holders and pin with (Ref# 5)Lock Pin.
13-298 FAN RAKE ATTACHMENT PARTS LIST
REF# PART# DESCRIPTION QUANTITY
1 13-310 Rake 5
2 13-306 Frame 1
3 HB-38-16-100 Bolt 3 /
8
- 16 x 1 4
HN-38-16 Nut 3 /
8
- 16 4
HWL-38 Lockwasher 3 /
8
4
4 HCP-12-450 Clevis Pin 1 /
2
x 4 1 /
2
1
5 HHP-18 Bridge Pin 1 /
8
1
6 19-107 Drawbar 1
7 HP-18-100 Cotter Pin 1 /
8
x 1 1
8 HCP-12-150 Clevis Pin 1 /
2
x 1 1 /
2
1
9 13-307 Hitch 2
10 HNCL-14-20 Center Lock Nut 1 /
4
- 20 5
11 HB-14-20-200 Bolt 1 /
4
- 20 x 2 5
FAN RAKE ATTACHMENT INSTRUCTIONS
1. Remove the complete rake assembly from the trap rake. Replace the clevis pin and bridge pin in the hitch
for future use with the rake.
2. Assemble (Ref# 9) Hitch to (Ref# 2)Frame using (Ref# 3)Hardware. Assemble (Ref# 6)Drawbar to the
hitch using (Ref# 4)Clevis Pin and (Ref# 7)Cotter Pin, as shown. The Different Holes in the hitch are for
adjusting the angle of the rakes.
3. Assemble the five (Ref# 1) Rakes to the (Ref# 2) Frame using 1 /
4
- 20 x 2 bolt and center lock nuts (Ref#
10 and 11). Slide the fan rake assembly under the rear of the trap rake to the hitch. Attach the (Ref# 6)
Drawbar to the hitch using the (Ref# 8) Clevis Pin and the (Ref# 5) Bridge Pin.
4. Hook the chains from the Frame to the hooks on the Rake Lift.