Smart Avi AVRouter - Manual (Page 21)

AVRouter Manual Version 1.0
Page 21
Chapter 6: Communication Protocol Chapter 6: Communication Protocol Chapter 6: Communication Protocol Chapter 6: Communication Protocol Chapter 6: Communication Protocol
The command to make the end of CAT5 line receiver (SLRX-RX300) switch between its local and remote sources
is as follows;
<0xBE><0xEF>
<0xBE><0xEF> <0xBE><0xEF> <0xBE><0xEF> <0xBE><0xEF>
Where;
<0xBE>
<0xBE> <0xBE> <0xBE> <0xBE> always always always always always 0xBE 0xBE 0xBE 0xBE 0xBE
<0xEF> <0xEF> <0xEF> <0xEF> <0xEF> always always always always always 0xEF 0xEF 0xEF 0xEF 0xEF
Frame address. Set by Hex switch on unit or position in Rack frame.
always always always always always 0x00 0x00 0x00 0x00 0x00
50 (0x32)
is Two bytes 0L = Receiver LOCAL Video/Audio, 1 =
Receiver REMOTE Video/Audio
< B C C >
< B C C > < B C C > < B C C > < B C C >
So if switching the Receiver on output 3 of Frame 2 to its local source send
<0xBE><0xEF><0x02><0x00><0x32><0x02><0x63>
<0xBE><0xEF><0x02><0x00><0x32><0x02><0x63> <0xBE><0xEF><0x02><0x00><0x32><0x02><0x63> <0xBE><0xEF><0x02><0x00><0x32><0x02><0x63> <0xBE><0xEF><0x02><0x00><0x32><0x02><0x63>
Get System Information Get System Information Get System Information Get System Information Get System Information
Cmd = 0xff
Databytes = NULL (none)
Unit will return a valid PSU as detailed above where Databytes are as follows
, ,
Where Product Type =
1 Byte;
0 = SmartNet V
1 = SmartNet X
3 = SLX-TX550
4 = SLX-RX300
Where Switch configuration =
2 Bytes;
Where Version =
3 bytes
Appendix A: RS232/422 Converter and Comms Cable Appendix A: RS232/422 Converter and Comms Cable Appendix A: RS232/422 Converter and Comms Cable Appendix A: RS232/422 Converter and Comms Cable Appendix A: RS232/422 Converter and Comms Cable
RS232/RS422 Converter RS232/RS422 Converter RS232/RS422 Converter RS232/RS422 Converter RS232/RS422 Converter
A suitable RS232/RS422 product can be purchased from KK Systems KK Systems KK Systems KK Systems KK Systems in Brighton, East