Skutt EnviroVent 2 - Manual (Page 14)

14
14 14
a
ccESSory
i
tEmS
Dual Intake Kit
The Dual Intake Kit is used when you are venting 2 kilns that are each at or under 12 Cubic Feet or when you are
venting a single kiln between 12 and 24 Cubic Feet. The kit contains the following items:
• Two 8 ft. x 3” Flexible Aluminum Duct
• One Spring Loaded Plenum Cup Assembly
Cast Plenum Cup
Fiber Gasket
Plenum Stand w/Base
Plenum Spring
• Four Hose Clamps
• One Y Duct Connector
Extension Kit
The Extension Kit is used when you need additional ducting than what is provided with a standard Envirovent 2.
The kit contains the following items:
• One 8 ft. x 3” Flexible Aluminum Duct
• Two Hose Clamps
• One 3“ Connector
Individual Fittings
a
CCessorIes
EnviroLink
The EnviroLink is an accessory item that can be ordered for the EnviroVent
and Envirovent 2 that works in conjunction with the Skutt KilnMaster or
GlassMaster controller. It allows you to program the controller to automatically
turn the vent on and off throughout a firing program. You simply enter an on/off
setting for each segment of a Ramp and Hold program while you are programming
the kiln. There are preset “vent programs” that can be run in conjunction with a
ConeFire Mode program as well. If ordering for a kiln that is equipped with a Link
Board, be sure to order the EnviroLink for Link Board version.
3” Connector 3” to 4” Connector 3” Y Duct Connector