English – Sim2 HT200 DMF User Manual

Page 9

ENGLISH

SWITCH ON FROM STAND-BY

By remote control: press one of 1...9
By keyboard: press Up or Down Arrow .

Fig. 17

When switching on from stand-by, the projector will turn on the
lamp; after a brief warm up period the image will be displayed

(green LED on).The input automatically selected will be the last
one memorised prior to switch off

(Fig. 17)

You may experience difficulties switching on the projector shortly
after switching off: the lamp may fail to come on as it is too hot.
Just wait a few minutes to cool it down.

SWITCHING OFF AND RETURNING TO STAND-BY

By remote control: press

By keyboard: press key

When switching off, the projector goes in to stand-by memorising
the input selection at the time of switch-off.
The fans will continue to work until the lamp has cooled down
(red and green LEDs flashing) and will stop automatically after
this period.

LED INDICATORS

The LED indicators, located in the top-rear of the projector,
provide information about the state of the projector (see table
below).

POWER OFF

INITIALIZATION

STATE

NOTES

INDICATORS

GREEN

RED

STANDBY

OPERATING

COOLING LAMP

WARNING

ERROR

The Power is turned off

Power button has been pressed and the software is initialized (15 s)

Projector is in standby mode

Projector is on

Projector is powering down; the fans are running to cool the lamp (1 min)

Problems to display one or more source

Internal circuit failure

OFF

FLASHING

OFF

FLASHING