Directed Electronics 550ESP - Manual (Page 35)

32
© 1999 Directed Electronics, Inc.
LED: Red light mounted somewhere in the vehicle. It is used to
indicate the status of your system. It is also used to report trig-
gers and faults in the system or sensors.
Shock Sensor: This system is packaged with a Stinger ™
DoubleGuard ® shock sensor. This sensor is mounted in the vehicle
and designed to pick up impacts to the vehicle or glass.
Transmitter: Hand-held, remote control which operates the vari-
ous functions of your system.
Trigger or triggered sequence: This is what happens when the
alarm “goes off” or “trips.” The triggered sequence of your system
consists of 30 seconds of siren sounding and parking light flashing.
Valet ® Switch: A small push button switch mounted somewhere
inside the vehicle. It is used to override the alarm when a trans-
mitter is lost or damaged, or to put it into Valet ® mode.
Warn Away ® response: Lighter impacts to the vehicle will gener-
ate the Warn Away ® response. It consists of several seconds of
siren chirps and parking light flashes.
Zone: A zone is a separate input that the alarm can recognize as
unique. Each input to the system is connected to a particular
zone. Often two or more inputs may share the same zone.