Directed Electronics 550ESP - Manual (Page 15)

12
© 1999 Directed Electronics, Inc.
To turn off, or disarm the security system, press again. You will
hear two chirps, and the parking lights will flash twice. If the
power locks are controlled by the system, the doors will also
unlock. The siren chirping either four or five times when disarming
indicates Tamper Alert, which is described in the Diagnostics
Section of this guide.
Your security system includes a High Security Disarm feature. After
6 seconds of trigger sequence, using the transmitter to disarm the
security system will only stop the trigger sequence (the siren will
stop and the parking lights will stop flashing). However, the sys-
tem will remain armed and the doors will stay locked. This is
extremely useful if you must stop the system from sounding, but
are unable to visually check the vehicle. This feature allows you to
silence and reset the security system when it is triggered, without
having to disarm the system.
If your remote transmitter is lost or damaged, you can manually
disarm your vehicle security system. To disarm the system without
a transmitter, you must have the vehicle's ignition key and know
where the Valet ® switch is located. Be sure to check with your
installer at the time of installation for both the location and the
preset response (1-5 presses) of the Valet ® switch.
Disarming Without a Transmitter
High Security Disarm
Disarming