Sierra Video 10 Series - Manual (Page 8)

SIERRA VIDEO
2
Warnings (continued)
 Route power cords and other cables so that they are not likely to be
damaged, or create a hazard.
 Dangerous voltages exist at several points in this product. To avoid personal
injury, do not touch unsafe connections and components when the power is
on.
 To avoid fire hazard, use only the specified type, correct voltage, and
current rating of fuse. Always refer fuse replacement to qualified service
personnel.
 Have qualified personnel perform safety checks after any completed service
 This is an FCC class A product. In a domestic environment, this product
may cause radio interference, in which case the user may be required to take
necessary measures.
Cautions
 Use the proper AC voltage to supply power to the switcher. When installing
equipment, do not attach the power cord to building surfaces.
 To prevent damage to equipment when replacing fuses, locate and correct
trouble that caused the fuse to blow before applying power.
 Use only the recommended interconnect cables to connect the switcher to
other frames.
 Follow static precautions at all times when handling the equipment.
 Leave the side, top, and bottom of the frame clear for air convection cooling
and to allow room for cabling. Slot and openings in the frame are provided
for ventilation and should not be blocked.
 Only an authorized Sierra Video technician should service the switchers.
Any user who makes changes or modifications to the unit without the
expressed approval of the Sierra Video will void the warranty.
Power Supply Cords
North American Power Supply Cords
This equipment is supplied with North American power cords with molded grounded plug
(NEMA-15P) at one end and molded grounding connector (IEC 320-C13) at the other
end. Conductors are CEE color coded, light blue (neutral), brown (line), and green/yellow
(ground). Operation of the equipment at voltages exceeding 130VAC will require power
supply cords that comply with NEMA configurations.
International Power Supply Cords
If shipped outside North America, this equipment is supplied with molded ground
connector (IEC 320-C13) at one end and stripped connectors (50/5mm) at the other end.
Connections are CEE color coded, light blue (neutral), brown (line), and green/yellow
(ground). Other IEC 320-C13 type power cords can be used if they comply with safety
regulations of the country in which they are installed.