Sierra Video 10 Series - Manual (Page 13)

SERIES 10 DA
7
Audio Connections
The Series 10 audio distribution amplifier frame (801017) uses a terminal strip design
containing 6 pin removable connectors for input and output connections. Each 6 pin
section of the strip that is fixed to the rear of the frame mates with an un-pluggable
mating half to which the actual wires are connected. This 6 pin group is one balanced
stereo audio line.
On the strips with 6 connectors, each connector is configured as follows;
Left +
Left –
Ground
Ground
Right –
Right +
On the strips with 5 connectors, each connector is configured as follows;
Right +
Right –
Ground
Ground
Left –
Left +
Note:
Be sure to be consistent with “+” and “-“ connections to maintain correct audio phase.
Mono modules use only the Right inputs and outputs on the 801017 frame.
Connections are silk-screened on the rear panel.
If the signal is balanced with no shield, omit the Ground connection.
If the signal is un-balanced, connect to the “+” and Ground. Leave the “_” pin open.