Sierra Video Sequoia Family - Manual (Page 22)

SIERRA VIDEO SYSTEMS
16
Control Processor DIP Switch Settings
Your switcher has been configured at the factory for the settings you are most likely to need.
However, if you want to configure the switcher differently, you can do so by setting the switches
located on the processor board (behind the front panel). Dip Switches and their action are given
in the table that follows;
DIP switch settings for software versions 11.30 or older
Important!
In a redundant processor system all DIP switches except S1-1 must be set identically on both processors
or the processor will flash it’s “I am sick” LED.