Sierra Video Tahoe Series 16 - Manual (Page 45)

Sierra Video Systems
39
Troubleshooting
Introduction
NOTES:
If the output signal is disturbed or interrupted by electromagnetic interference, the
signal should return and stabilize when the interference ends. If not, turn the
power switch off and on again to reset the switcher.
If the following recommended actions still do not result in satisfactory operation,
please consult your Sierra Video Systems Dealer.
Power and Indicators
Problem Remedy
No power  Confirm that the rocker switch is in the “ON” position, and that the power
lamp is illuminated.
 Confirm that power connections are secured at the switcher and at the
receptacle. Make sure the receptacle is active, with the proper mains
voltage.
 If there is still no power, check the fuse. Remove power cord from the AC
outlet and from the switcher and then remove the fuse holder located
above the power connector. Confirm that the fuse is good by looking at
the fuse wire connected to the ends of the fuse. If the wire is separated,
replace the fuse.
Chapter 5