Sierra Video RS-485 Pushbutton Control Panels - Manual (Page 17)

SIERRA VIDEO
11
Installation
Introduction
In routers with processor software version 7.1 or newer the RS-485 pushbutton control
panels can be configured to “block” outputs and to allow or prevent specific levels from
being switched. For older software versions contact Sierra Video.
The Sierra Video TyLinx Pro or MediaNav software programs are used to setup the
“general settings” of the control panel. Refer to the TYLINX PRO or MediaNav manual,
“Control Panel, General Settings” sections of the manual.
Installation procedures are similar for all units covered under this manual. Exceptions, if
any, have been noted in each of the following paragraphs.
Rack Mounting
Carefully inspect the control panel to ensure that there has been no shipping damage.
Make sure all shipping material is removed from the unit.
Each of the control panels described in this manual can be rack mounted in a standard
19" (RU) EIA rack assembly and includes rack "ears" at the ends of the front of the panel.
None of the control panels require spacing above or below the unit for ventilation.
To rack mount any of the control panels, simply place the unit's rack ears against the rack
rails of the rack, and insert proper rack screws through each of the holes in the rack ears.
Always rack mount the control panel prior to plugging the unit into a power receptacle or
attaching any cables.
CAUTION!
The operating temperature range of this product is 0 to 40ºC. Do not exceed the maximum (40ºC)
or minimum (0ºC) operating temperature.
If installed in a closed or multi-rack assembly, the operating ambient temperature of the rack
environment may be greater than the room ambient temperature. Therefore, consideration should
be given to installing the equipment in an environment compatible with the manufacturer’s
maximum rated ambient temperature (YMRA).
Installation of the equipment in a rack should be such that the amount of air flow required for safe
operation of the equipment is not compromised.
Chapter 2