Sensoray 2410 - Manual (Page 9)

2410 Instruction Manual 7 Specifications
Chapter 5: Specifications
Table 4: Communications Interface
Network Physical layer 10BaseT, 100BaseTx Ethernet
Bit rate 10/100 Mbps, auto-detecting
Isolation 1500Vrms
Protocols ARP, HTTP, ICMP, IPv4, TCP, Telnet
Configuration Programmable via HTTP (static ARP): IP address, netmask, gateway
HTTP Server Concurrent sessions 1
Functions Status, configuration, I/O monitor/control
TELNET Server Concurrent sessions 3
Time-out interval 5 minutes (default, programmable via HTTP), programmable per session via shell
Table 5: General Purpose Digital I/O
Digital Inputs Input type 5V TTL/CMOS compatible
Off state input voltage +2.0 to +5.25 VDC
On state input voltage 0.0V to +0.8 VDC
Input impedance 10 Kohm
Sample rate 1 KHz
Debounce period 0 to 255 milliseconds, 1ms resolution
Digital Outputs Output type Active low, open collector with 10 Kohm pullup resistor
Output current, on state 24mA maximum
PWM resolution 1 ms on-time, 1 ms off-time (max frequency = 500 Hz)
Table 6: Power and Environmental
Module Power Input power 24VDC ±5% @90mA (digital outputs off, no external loads)
Auxiliary Power Output Voltage +5VDC ±5%, referenced to module input power supply return
Current 400mA maximum
Temperature Operating range -25 to 85°C
Table 7: Mechanical
Module Dimensions Outer dimensions 5.0H x 4.1W x 2.2D inches. W = overall DIN rail length. D = module height from DIN rail
back panel; additional clearance required for field wiring.
Mating Connectors
(not included) ETH RJ-45 plug, AMP 554169 or equivalent
DIO 50 pin socket, Tyco 1-1658621-0 or equivalent
AUXPWR
Molex 22-01-3047 with 08-50-0114 pin contact (4), or equivalent